Fig. 69 Indicator lamp in the dash panel: front passenger front airbag switched off (variant A), front passenger front airbag switched on (variant B)
First read and observe the introductory information and safety warningsLit up | Location | Possible cause | Solution |
---|---|---|---|
Instrument cluster. | Fault in airbag and belt tensioner system. | Go to a qualified workshop to have the system checked immediately. | |
Dash panel A. | Fault in the airbag system. | Go to a qualified workshop to have the system checked immediately. | |
Front passenger front airbag switched off. | Check whether the airbag should stay switched off. | ||
Dash panel B. | Front passenger front airbag switched on. | No solution – the indicator lamp will disappear automatically approximately 60 seconds after the ignition is switched on, or after the front passenger front airbag is switched on using the key-operated switch. |
Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.
If the indicator lamp PASSENGER AIR BAG is not continuously lit or if it lights up together with the indicator lamp in the instrument cluster when the front passenger front airbag is switched off, there may be a fault in the airbag system .
WARNING
If there is a fault in the airbag system, the airbag may not trigger correctly, may not trigger at all or may trigger unexpectedly. This can cause severe or fatal injuries.NOTICE
To avoid damage to your vehicle, always observe the indicator lamps and associated warning texts.Removing and installing manually operated anti-dazzle interior mirror,
without rain and light sensor -G397- and front camera for driver assist systems
-R242-
Removing
–
Turn interior mirror -2- anti-clockwise
-arrow- by 90° (1/4
turn).
–
Remove interior mirror -2- from
glued-on retaining plate -1-.
Installing
Note
...
Removing and installing air distribution housing
Note
The illustration shows a left-hand drive vehicle. The
removal and installation procedure is identical for both
versions.
Removing
–
Remove heater ...
Balancing wheel, checking radial and lateral run-out on wheel rim
–
Attach rim to wheel balancing machine.
–
Use the centring system for wheel balancing machines -VAS
5271-.
–
Preload tyre gauge approx. 2 mm.
–
Tu ...