Volkswagen Golf Service & Repair Manual: Identification plates
| There are different types of identification plates. |
| When the auxiliary heater is replaced, check the type plate
and the duplicate plate and replace as necessary. |
|
|
|
| Identification plate on auxiliary heater |
| The date of first use is entered on the lower section of the
data plate. |
| The year the unit was first brought into operation must be
entered on the “Genuine part” identification plate. |
|
|
|
| Duplicate identification plate for auxiliary heater |
| In the engine compartment of the vehicle, there is a second
(duplicate) identification plate attached to the right of the
lock carrier (when looking in direction of travel). If there is
any doubt concerning the type of the auxiliary heater, always
observe the identification plate attached directly to the
auxiliary heater. |
|
|
|
Thoroughly clean all connections and adjacent areas before
disconnecting.
Place parts that have been removed on a clean surface and
cover ...
–
→ Chapter „Safety precautions when working on high-voltage
system“ Comply with notes.
–
Read self-diagno ...
Other materials:
Seat belt protection
Fig. 63 Driver restrained by a properly
positioned seat belt during a sudden braking manoeuvre
First read and observe the introductory information
and safety warnings Correctly fastened seat belts can make a major difference.
When fastened properly, seat belts hold the vehicle occupants in ...
Spraying the evaporator with the suction feed spray-gun -V.A.G 1538- and
spray lance
Spray the evaporator with Contra Sept directly using a spray
lance (approx. 10 bar). Contra Sept neutralises microbes and
bacteria directly at the evaporator.
In order to enable access to the evaporator, some
preliminary work and differe ...
Tools and materials commercially available
Caution
Non-authorised tools or materials (e.g. leak
inhibitor additive) may cause damage or adversely
influence the system.
Only tools and materials a ...
© 2016-2026 Copyright www.vwgolf.org
