Volkswagen Golf Service & Repair Manual: Hydraulic system

Volkswagen Golf Service & Repair Manual / Brake system (hybrid) / Brakes, hydraulics, regulator, servo / Hydraulic system

General notes on brake fluid

Only use new brake fluid conforming to VW standard (VW 501 14).

Note

Brake fluid is poisonous. Also due to its corrosive effect brake fluid must not come into contact with paintwork.

Brake fluid is hygroscopic, which means it absorbs moisture from the ambient air and should therefore always be stored in air-tight containers.

Rinse off spilled brake fluid using plenty of water.

Changing brake fluid

Work instructions

Unbolt relevant brake line at brake caliper or wheel brake cylinder; catch escaping brake fluid and dispose of this as per regulations. &nb ...

Bleeding hydraulic system following standard procedure

Note Bleeding the hydraulic system using brake filling and bleeding equipment -VAS 5234- is described. A pre-pressure of 2 ...

Other materials:

Fitting control unit to hydraulic unit
Special tools and workshop equipment required ESD workplace -VAS 6613- Torque screwdriver -V.A.G 1624- Torx bit T25 Note ...

Notes for wheel alignment
Wheel alignment must be performed only using a VW/AUDI-approved wheel alignment unit! Whenever wheels are aligned, both the front and rear axles must be measured. – Carry alignment out with the wheel alignm ...

ACC — Adaptive Cruise Control
Note On vehicles with ACC, the trim in the right-hand cover of the front bumper must not be painted during a repair paint job or replacement. The ACC system located behind can become operational due to the thickness ...