IntroductionConicity
Conicity is caused by a slight offset of the tread and/or
the belt (amounting to a few tenths of a millimetre) relative to
the geometric centre of the tyre. Taper is not visible and
cannot be measured with equipment available in the workshop.
& ...
Paintwork in Aftersales
Panels galvanised on both sides
Earlier attempts at flanged pairings have resulted in the
fact that only panels that are galvanised on both sides are used
now. Only in this way can the cathodic protection and the
barrier effect of the zi ...
Overview of fitting locations - components not located in passenger
compartment, Golf Variant LHD
1 -
Exhaust ventilation for passenger compartment
Checking
→ Chapter
Removing and installing
→ Chapter
2 -
Humidity sender for air conditioning system -G260-
Check v ...