Cavity sealing, rear body
Technical dataBalancing wheel, balancing wheel with finish balancer
Before you start balancing the wheels, the following
requirements must be met.
Tyre pressure must be OK.
Tread must not be worn on one side. Tread depth should be at
least 4 mm.
T ...
Removing and installing Hall sender -G40-
Removing
–
Release hose clips -1- and
-2-, and remove air pipe.
–
Disconnect electrical connector -1-.
...
Assembly overview - pistons and conrods
1 -
Bolts
Renew
Oil threads and contact surface
30 Nm + 90°
2 -
Conrod bearing cap
The conrod bearing cap only fits in one position and only on the
appropriat ...