VW Golf manuals

Volkswagen Golf Service & Repair Manual: General repair notes

Before starting work on the fuel supply system, the following steps must be performed:
Before starting work, the extraction hose of a switched-on exhaust gas extraction system must be laid near to the assembly opening of the fuel tank.
It is used to extract fuel fumes.
If no exhaust gas extraction system is available, a radial fan with a displacement greater than 15 m3/h can be used providing that motor is not in air flow.
Prevent skin contact with fuel! Wear fuel-resistant gloves!
Interrupt power supply to fuel system pressurisation pump -G6- → Current flow diagrams, Electrical fault finding and Fitting locations.
Draining fuel tank → Chapter
   
Routing and securing lines
Risk of damage to lines Lines may become damaged by moving or hot components. –  Route lines in their original positions. –  Ensure ...

Fuel supply, gas operation
...

Other materials:

Removing and installing electronics box (E-box)
Removing –  With ignition switched off, disconnect earth cable from battery → Chapter. Diesel engine –  Remove engine control unit and lay to one side with ...

Removing and installing digital sound package control unit -J525
Special tools and workshop equipment required     Protective cap for wiring harness connector -VAS 6223/9- If the control unit is replaced, select the Replace function of the resp ...

Removing and installing shock absorber, multi-link suspension, left shock absorber
Special tools and workshop equipment required Torque wrench -V.A.G 1332- Torque wrench -V.A.G 1410- Spring compressor -V.A.G 1752/1- Spring retainer -V.A.G 1752/3A- Adapter -V.A.G 1752/9-, not illu ...

© 2016-2024 Copyright www.vwgolf.org