Volkswagen Golf Service & Repair Manual: General repair instructions
| – |
→ Chapter „Safety precautions when working on high-voltage
system“ Comply with notes. |
| – |
Read self-diagnosis of auxiliary heater using vehicle
diagnostic tester. |
| – |
When parts of the fuel system are removed or renewed, ensure
that all components for fuel delivery to the
auxiliary/supplementary heater are properly installed. |
| – |
Mark coolant hoses before removing to avoid any confusion
when reconnecting. |
| Following repair work in the vicinity of the
auxiliary/supplementary heater fuel line, check the following
points: |
| that the fuel lines are routed flush with the vehicle
underbody and are protected against mechanical damage. |
| that the auxiliary heater fuel line is protected from
heating which might disturb operation. |
| that the fuel line does not come in contact with parts that
become hot. |
|
|
|
There are different types of identification plates.
When the auxiliary heater is replaced, check the type plate
and the duplicate plate and replace a ...
Other materials:
Dimensions - lettering on rear lid
Note
When fitting the lettering, observe the fitting notes
→ Anchor.
1 -
Lettering
Model designation.
2 -
Lettering
Engine designation
For technical designations without engine designation, a ...
Assembly overview - driver side airbag
1 -
Catch
To release, use a Torx screwdriver T25 of approx. 100 mm length
2 -
Steering column electronics control unit -J527-
With airbag coil connector and return ring with slip ring -F138-
Assembly overview
→ Elec ...
Repairing smooth pipe
Smooth pipe with a diameter or 5x1 mm or 6x1 mm can be
repaired with EPDM hose.
–
Cut damaged section at right angles out of smooth pipe which
is to be repaired.
–
Select the appropr ...
© 2016-2026 Copyright www.vwgolf.org
Identification plates