Volkswagen Golf Service & Repair Manual: General notes
Cleanliness specifications for working on
the auxiliary heater and fuel system |
When working on the fuel supply and injection system, pay
careful attention to the following “rules”: |
Thoroughly clean all unions and surrounding areas before
disconnecting. |
Place removed parts on a clean surface and cover. Use only
lint-free cloths. |
Carefully cover opened components or seal if repairs cannot
be carried out immediately. |
Install clean components only. Do not remove replacement
parts from packing until immediately before installing. Do not
use parts that have not been stored in their packing (e.g. in
tool boxes etc.). |
When the system is open: Do not work with compressed air. |
Immediately seal open lines and unions with clean plugs, for
example from engine bung set -VAS 6122-. |
Protect detached electrical connections against dirt and
moisture and only connect when they are dry. |
|
|
|
Engine number, engine data
Engine code
CJZA
CJZB
CYVA
CYVB
CHPA
CMBA
Emission standards
EU 5 plus
EU 5 plus
EU 6
EU 6
EU ...
Other materials:
Checklist
To ensure your own safety and the safety of your passengers, observe
the following actions in the specified order :
Stop the vehicle at a safe distance away
from moving traffic and on a suitable surface .
Switch on the hazard warning lights using
the button .
Switch on the ...
Assembly overview - side trim panel
Note
The illustration shows the side trim panel on the left side. The
right-hand side is similar (mirror image of left-hand side).
1 -
Side trim panel
Removing and installing
→ Chapter
2 -
Clip
...
Removing and installing rear outer belt end fitting
Removing
–
Unscrew bolt -1- on belt end
fitting -2-.
Installing
The anti-rotation tab -arr ...
© 2016-2024 Copyright www.vwgolf.org