Volkswagen Golf Service & Repair Manual: General body repairs, interior
- Technical data
- Interion equipment
- Pasanger protection
- Seat belts
- Child seat anchors
- Airbag system
- Airbag control unit
- Driver side airbag
- Front passenger side airbag
- Side airbags
- Curtain airbags
- Knee airbags
- Airbag crash sensors
- Seat belt verification
- Trim, noise insulation
- Front door trims
- Rear door trims
- Dash panel
- Dash panel central tube
- Interior trims
- Luggage compartment trims
- Roof trims
- Seat frames
- Overview of seat variants
- Front seats
- Rear seats
- Removing and installing cover frame for through-loading aperture
- Seat padding, covers
Removing and installing Bowden cable
Removing
WARNING
It is not permissible to loosen bolts other than
those specified.
...
Technical data
...
Other materials:
Main beam assist
First read and observe the introductory information
and safety warnings Main beam assist (Light Assist)
Within the limits of the system, the main beam assist automatically switches
the main beam on at speeds of over approximately 60 km/h (37 mph), depending on
environmental and traffic con ...
Installing engine
Procedure
Engine/gearbox assembly secured to engine support T10497.
Note
Renew bolts that are tightened with specified tightening
angle.
Renew self-locking nuts and bolts ...
Moving mechatronic unit for dual clutch gearbox -J743- into removal position
by hand
Note
Only if you cannot set the mechatronic unit to removal position with
the vehicle diagnostic tester, you must set the unit by hand to removal
position.
Sometimes, the mechatronic unit cannot be removed. In this case, the
gear actuator for 6th gear ...
