Volkswagen Golf Service & Repair Manual: General

Volkswagen Golf Service & Repair Manual / Wheels and Tyres Guide - General Information / Handling problems / Vehicle pulls to one side / General

Perform a road test to determine whether a vehicle is pulling to one side and if so, which side. If the vehicle pulls to one side → Chapter.

When wheel alignment is checked, include the wheel alignment test results in tyre complaint report.

Manufacturer's tolerances can lead to a slight amount of taper (asymmetry) in the tyre carcass. The rolling tyre then develops a lateral force which acts directly on the wheel suspension, leading to self-steering of the vehicle. Strategic rotation of the wheels can balance out this self-steering behaviour.

Vehicle pulls to one side

...

Conicity

Conicity is caused by a slight offset of the tread and/or the belt (amounting to a few tenths of a millimetre) relative to the geometric centre of the tyre. Taper is ...

Other materials:

Overview of fitting locations – adaptive cruise control, variant 1
1 - Trim for radar sensor 2 - Adaptive cruise control unit -J428- Removing and installing → Chapter Calibrating → Chapter 3 - Bolt Qty. 2 ...

Overview of the menu structure
First read and observe the introductory information and safety warnings The following menu structure shows how the Volkswagen information system menus in the instrument cluster display are structured. The size and layout of the Volkswagen information system menu depends on the vehicle electr ...

Removing and installing air conditioner compressor fuse -S355-
Special tools and workshop equipment required Torque wrench -V.A.G 1783 Torque wrench -V.A.G 1331- Removing ...