Volkswagen Golf Service & Repair Manual: Gaskets, seals
After removing gaskets and seals, always inspect contact
surface of housing or shaft for burrs resulting from removal or
for other signs of damage. |
Before installing seals, lightly oil outer diameter and
half-fill space between sealing lips
-arrow- with sealing grease -G 052 128 A1-. |
The open side of the oil seal faces the side with fluid
filling. |
Only use DSG transmission oil. Other lubricants will cause
problems in function. |
After renewing gaskets, O-rings and seals - drain gear oil
completely and refill with new oil
→ Chapter. |
|
|
|
To ensure flawless and successful gearbox repairs, the
greatest care and cleanliness as well as the use of good and
proper tools are essential. Of course, the basic r ...
Loosen and tighten securing bolts and securing nut for
covers and housings diagonally.
Specified torques settings are specified for unoiled bol ...
Other materials:
Removing and installing coolant pipes at heat exchanger (Valeo)
Note
There are different designs and makes of heater and air
conditioning unit. The individual components of the various
heaters and air conditioning units are similar but not identical
(distinguishing features
→ Chapter). The c ...
Removing and installing front ashtray
Removing
–
Remove front ashtray -1-
upwards from centre console -2-.
Installing
Installation is carried out in reverse order.
...
Assembly overview - sun visors
Note
The assembly overview is shown for the driver side. The assembly
overview for the front passenger side is analogous.
1 -
Sun visor
Removing and installing
→ Chapter
2 -
Sun visor mount
...
© 2016-2024 Copyright www.vwgolf.org