Removing and installing actuator
DoorAssembly overview - drive shaft, constant velocity joint VL100
1 -
Outer constant velocity joint
Renew only as complete unit
Removing
→ Anchor.
Installing: drive onto shaft to stop using plastic hammer
Checking
→ Chapter
2&nb ...
Assembly overview - impact bar
Volkswagen R GmbH, optional equipment, “R Line” and “R”
1 -
Impact bar
Different versions, allocation
→ Electronic Parts Catalogue “ETKA”
Removing and installing
→& ...
Overview of fitting locations - fuel supply system, Golf Variant
Note
Fuel lines are secured with O-type clips. These O-type clips
must always be renewed every time they are removed.
Start engine if fuel tank was empty. Then start the
auxiliary heater repeatedly until the heater d ...