Volkswagen Golf Service & Repair Manual: Flat connector systems
 Note
| If necessary, any housing catches in place (secondary
locking mechanisms) must be released or removed prior to
disengaging the contacts using the prescribed tool
→ Chapter. |
|
|
|
| Flat connector with one locking tab: |
| – |
Insert the release tool appropriate for the contact housing
in the release port of the contact housing. |
| – |
Grab hold of the contact by the wire and push it lightly
into the contact housing -arrow-. |
Note
| By pushing the contact in the direction of the contact
housing, the locking tab of the contact is lifted up by the
housing edge and can be disengaged using the release tool. |
|
|
|
| – |
At the same time, push the release tool in the direction of
the contact housing and pull out the released contact from the
contact housing -arrow-. |
| – |
The release tool can be pulled out of the contact housing
again once the contact has been removed. |
|
|
|
| Flat connector with two locking tabs: |
| – |
Insert the release tool appropriate for the contact housing
in the release port of the contact housing. |
| – |
Grab hold of the contact by the wire and push it fully into
the contact housing -arrow-. |
Note
| By pushing the contact in the direction of the contact
housing, the locking tabs of the contact are lifted up by the
housing edge and disengaged using the release tool. |
|
|
|
| – |
At the same time, push the release tool in the direction of
the contact housing and pull out the released contact from the
contact housing -arrow-. |
| – |
The release tool can be pulled out of the contact housing
again once the contact has been removed. |
|
|
|
| – |
Insert the release tool appropriate for the contact housing
in the release port of the contact housing. |
| – |
Grab hold of the contact by the wire and push it lightly
into the contact housing -arrow-. |
Note
| By pushing the contact in the direction of the contact
housing, the locking tabs of the contact are lifted up by the
housing edge and disengaged using the release tool. |
|
|
|
| – |
At the same time, push the release tool in the direction of
the contact housing and pull out the released contact from the
contact housing -arrow-. |
| – |
The release tool can be pulled out of the contact housing
again once the contact has been removed. |
|
|
|
Note
If necessary, any housing catches in place (secondary
locking mechanisms) must be released or removed prior to
disengaging the contacts using the ...
Note
If necessary, any housing catches in place (secondary
locking mechanisms) must be released or removed prior to
disengaging the contacts using the ...
Other materials:
Renewing air conditioner compressor
Note
On vehicles equipped with an electrical air conditioner
compressor, de-energise the high-voltage system before removing
the air conditioner compressor.
→ Electric drive; Rep. gr.93
...
Assembly overview - brake pedal, RHD vehicles
The brake pedal travel must not be restricted by additional floor
coverings.
Note
Do not lubricate or grease the pivot pin. The pivot pin must remain
dry.
1 -
Bolt
20 Nm
2 -
Mounting b ...
Assembly overview - drive unit of air conditioner compressor, Golf GTE
1 -
Electrical air conditioner compressor -V470-
With control unit for air conditioner compressor -J842- and
electrical air conditioner compressor -V470-
→ Chapter „Removing air conditioner compressor from and installing t ...
© 2016-2024 Copyright www.vwgolf.org
Round connector systems
Special connector systems