Fig. 248 Rear bumper on the right-hand side: removing the cover
Fig. 249 Rear bumper on the right-hand side: screwing in the towing eye
First read and observe the introductory information and safety warningsThe towing eye is screwed into a threaded hole behind a cover on the right of the rear bumper . In vehicles with a factory-fitted towing bracket there is no mounting for the removable towing eye behind the cover. To tow, fit and use the ball coupling , .
Comply with the notes on towing .
Fitting the towing eye at the rear (vehicles without factory-fitted towing bracket )
NOTICE
Introduction
This chapter contains information on the following subjects:
→ Display and indicator lamps
→ Operating the cruise control system (CCS)
The cruise control system (CCS) helps to maintain an individual set speed when
the vehicle is travelling forwards at speeds of more than ...
Noises from shock absorbers
Shock absorbers are often replaced because of noises
(rumbling, etc.) experienced by the customer. Inspections on the
test rig and in the vehicle have shown that in approx. 70 % of
these cases there is no case for complaint. The replacement was
not justi ...
Indicator lamp
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Engine management system fault (Electronic Power Control).
The engine should be checked by a qualified workshop
as s ...