Volkswagen Golf Service & Repair Manual: Fitting control unit to hydraulic unit
Special tools and workshop equipment
required |
Torque screwdriver -V.A.G 1624- |
|
|
|
Special tools and workshop equipment
required
ESD workplace -VAS 6613-
Torx bit T25
I ...
Other materials:
Checking radial and lateral runout on wheels and tyres with tyre gauge
Checking lateral run-out
–
Preload tyre gauge approx. 2 mm.
–
Fit tyre gauge to side wall of tyre.
–
Turn wheel slowly.
...
Removing and installing bumper cover
Volkswagen R GmbH, optional equipment, “R Line” and “R”
Note
The removal and installation procedures for the bumper cover
may vary slightly, depending on vehicle model.
Spec ...
Noises from shock absorbers
Shock absorbers are often replaced because of noises
(rumbling, etc.) experienced by the customer. Inspections on the
test rig and in the vehicle have shown that in approx. 70 % of
these cases there is no case for complaint. The replacement was
not justi ...
© 2016-2024 Copyright www.vwgolf.org