Side viewMoving mechatronic unit for dual clutch gearbox -J743- into removal position
by hand
Note
Only if you cannot set the mechatronic unit to removal position with
the vehicle diagnostic tester, you must set the unit by hand to removal
position.
Sometimes, the mechatronic unit cannot be removed. In this case, the
gear actuator for 6th gear ...
Removing and installing relay and fuse carrier behind dash panel, RHD
vehicles
Removing
–
With ignition switched off, disconnect earth cable from
battery
→ Chapter.
–
Remove dash panel
→ General body repairs, interior; Rep. gr.70.
...
Removing and installing wiper motor -V-
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Torque wrench -V.A.G 1331-
Note ...