Volkswagen Golf Service & Repair Manual: Exploded view - mechatronic unit

Volkswagen Golf Service & Repair Manual / 7- speed dual clutch gearbox 0CW / Gearbox mechanism, operation, contruction, diff / Mechatronic unit / Exploded view - mechatronic unit

Exploded view - mechatronic unit

1 -

Bolt

For securing mechatronic unit for dual clutch gearbox -J743- on gearbox housing.

Qty 3, M8 x 35

Always renew after removing.

Specified torque and tightening sequence → Fig.

2 -

Bolt

For securing mechatronic unit for dual clutch gearbox -J743- on gearbox housing.

Qty 4, M8 x 90

Always renew after removing.

Specified torque and tightening sequence → Fig.

3 -	Mechatronic unit for dual clutch gearbox -J743-

Note

Observe the following when installing a new mechatronic unit:

After unpacking a new mechatronic unit, do not discard the packaging or the red cap on the breather pipe. These will be needed for returning the old mechatronic unit.

A »new« mechatronic unit is correctly filled with oil. Do not drain or top up oil.

Recalibrate the immobiliser after installing a »new« mechatronic unit.

→ Chapter „Removing and installing mechatronic unit for dual clutch gearbox -J743-“

→ Chapter „Moving mechatronic unit for dual clutch gearbox -J743- into removal position by hand“

Mechatronic unit for dual clutch gearbox -J743- - specified torque and tightening sequence

Note

Always renew after removing.

–	Tighten bolts in 4 stages as follows:

Exploded view - mechatronic unit

Stage	Bolts	Specified torque
1.	-A-	Screw in to contact by hand.
2.	Remove guide bolts -T10406-.
3.	-B-	Screw in to contact by hand.
4.	-A, B-	Tighten to 10 Nm in diagonal sequence.

Component	Specified torque
Engaging lever cover	8 Nm

Mechatronic unit

...

Removing and installing mechatronic unit for dual clutch gearbox -J743

Special tools and workshop equipment required Vehicle diagnostic tester Us ...

Other materials:

Assembly overview - radiator and radiator fan
1 - Radiator Removing and installing → Chapter Change coolant after renewing. 2 - Coolant hose Pull out retaining clip to remove. Connecting → Fig. ...

Contents of the breakdown set
Fig. 227 The breakdown set First read and observe the introductory information and safety warningsThe breakdown set may be located in various places in the vehicle, e.g. in the side stowage area of the luggage compartment or under the floor covering in the variable luggage compartment. It in ...

Removing and installing holder for heater and air conditioning unit
Note Leave the holders in the vehicle on removing the heater and air conditioning unit. The illustration shows a left-hand drive vehicle. Removing – Re ...