Checking adjustment of assembly mountings (engine and gearbox mountings)
Procedure
The following specifications must be obtained:
There must be a distance of -a-
= 10 mm between engine support -2-
and engine mounting -1-.
...
Removing and installing air distribution flap control motor -V428-, RHD
vehicles
Special tools and workshop equipment
required
Vehicle diagnostic tester
First carry out the following work:
–
Switch off all electrical consumers.
–
...
Assembly overview - axle beam
1 -
Cover
2 -
Bolt
Renew after removing
50 Nm +45°
3 -
Bolt
Renew after removing
Tighten in unladen state
→ Chapter.
...