First read and observe the introductory information and safety warnings
One-touch opening and closing
One-touch opening and closing makes it possible to fully open and close the windows. The individual buttons do not have to be held down to do this.
For one-touch closing: pull the button for the appropriate window up briefly into the second position.
For one-touch opening: press the button for the appropriate window down briefly into the second position.
Stopping the one-touch function: press or pull the button for the appropriate window again.
Restoring one-touch opening and closing
One-touch opening and closing is deactivated if the vehicle battery has been disconnected or discharged while the windows were not fully closed. The function will have to be reset.
The one-touch function can be restored for individual windows or for several windows at the same time.
Convenience opening and closing
The windows can be opened and closed from outside the vehicle using the vehicle key:
During convenience closing, the windows and the electric panorama sliding/tilting roof close.
A variety of settings related to window operation can be made and adjusted using the button and the and Open and close function buttons .
WARNING
Improper or unsupervised use of the electric windows can cause serious injuries.One-touch opening and closing and the roll-back function will not work if there is a fault in the electric windows. Go to a qualified workshop.
Radar sensor
Fig. 174 In the front bumper: radar sensor
First read and observe the introductory information
and safety warnings A radar sensor is fitted to the front bumper to monitor
the traffic situation . Vehicles travelling ahead can thus be detected up to a
distance of approximately 120 m.
T ...
Front brakes
Item
PR No.
1ZF
1
Brake caliper
FS
III (15”)
2
Brake pad,
thickness
mm
12
Brake pad, wear limit
without backplate
mm
2
3
Brak ...
Technical data
General repair instructions
Repairing electrical wiring harnesses and connectors
→ Electrical System, General Information; Rep. gr.97
Releasing and dismantling connector housings
→ Electrical Sys ...