Brake fluid
IntroductionVehicles with torsion beam axle
The connecting pipe can be cut through at the cutting point
in order to renew the centre and rear silencers separately.
Cutting point is marked by an indentation on circumference
of exhaust pipe.
Special tools and ...
Notes on releasing and dismantling contact housings
Note
Observe the general notes on repairs to the vehicle
electrical system
→ Chapter.
To release, always use the correct release tools. Under no
circumstances should the contacts be pulled out of the ...
Removing tyres, wheels without and with tyre pressure monitoring
If fitted, check tyre pressure sensor using vehicle
diagnostic tester, and renew it as necessary.
Note
The tyre pressure sensor (if fitted) must not come into
contact with water or be blown upon with compressed air w ...