Transporting
IntroductionSetting vehicle to initial position for wheel alignment
If measured values are outside specified tolerances, this
may be because the vehicle is inclined.
Right-hand drive vehicles or e.g. vehicles with an automatic
gearbox may lean to one side slightly.
This is due to the ins ...
Ensuring proper assembly temperature for tyres
Caution
Risk of damage to tyres due to excessive heat.
Never heat tyres with a radiator or hot air blower.
Heat tyres with warm water or warm air (m ...
Removing and installing fresh air/recirculated air, air flow flap control
motor -V425-, LHD vehicles
Special tools and workshop equipment
required
Vehicle diagnostic tester
First carry out the following work:
–
Switch off all electrical consumers.
–
...