Operation
IntroductionRemoving and installing rear left vehicle level sender -G76-, multi-link
suspension, four-wheel drive
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Removing
–
Disconnect co ...
Calibrating Blind Spot Monitor control unit -J1086-/-J1087-
Note
Before the actual calibration process of the control units,
the calibration unit -VAS 6350- needs to be set up as described
in the following chapter.
Special tools and workshop equipment
required
  ...
Removing and installing storage compartment in roof headliner
Removing
–
Switch off ignition.
–
Unclip cover -1- from storage
compartment in roof headliner -3-.
–
Remove front interior light -WX1--2-
→ Elec ...