Volkswagen Golf Owners Manual: Display and indicator lamps

Volkswagen Golf Owners Manual / While driving / Driver assist systems / Cruise control system (CCS) / Display and indicator lamps

Fig. 160 Instrument cluster display: cruise control (CCS) status display

First read and observe the introductory information and safety warnings

CCS displays

Status :

CCS switched off temporarily. The stored speed is shown in small numbers or displayed in a darker shade.
System fault. Proceed to a qualified workshop.
CCS switched on. Speed memory is empty.
CCS is active. Stored speed in large figures.

Indicator lamp

Lit up	Possible cause
	CCS or the speed limiter is controlling the speed.

Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.

WARNING

Failure to observe illuminated warning lamps and text messages can lead to your vehicle breaking down in traffic, and can cause accident and serious injury.

Never ignore any illuminated warning lamps or text messages.

NOTICE

Failure to observe illuminated indicator lamps and text messages can lead to your vehicle being damaged.

If the CCS, ACC or speed limiter were switched on when the ignition was switched off, the CCS or ACC will be switched on automatically the next time the ignition is switched on. However, no speed is stored. The speed limiter's last set speed remains stored.

Displays can vary as different versions of the instrument cluster are available.

Introduction

This chapter contains information on the following subjects: → Display and indicator lamps → Operating the cruise control system (CCS) The cruise control system (CCS) helps ...

Operating the cruise control system (CCS)

Fig. 161 On the left of the steering column: switch and buttons for operating the CCS Fig. 162 Left-hand side of the multifunction steering wheel: buttons for operating the CCS First read and ...

Other materials:

Removing and installing brake pads or linings
Special tools and workshop equipment required Vehicle diagnosis, testing and information system -VAS 5051- Tool set for brake bleeding -VAS 6564- Insert tool with ratchet -VAS 6784- Bit attachment (7 mm) -T10503- ...

Removing and installing voltage regulator, manufacturer: Valeo
Special tools and workshop equipment required Torque wrench -V.A.G 1783- Removing – Remove alternator -C- → Chapter. ...

Assembly overview - bonnet
1 - Bonnet Removing and installing → Chapter Adjusting → Chapter 2 - Adjustment buffer Qty. 2 3 - Insulation Removing and installing → Chapter ...