Volkswagen Golf Service & Repair Manual: Disconnecting and connecting battery, vehicles without high-voltage system
Caution
Observe the following instructions and precautions
on safety when working on pyrotechnic components: |
Contrary to the following description, the battery
must be disconnected with the ignition SWITCHED ON when
working on pyrotechnic components (e.g. airbags, belt
tensioners)
→ General body repairs, interior; Rep. gr.00. |
|
Special tools and workshop equipment
required |
|
|
|
Torque wrench -V.A.G 1783- |
– |
Remove ignition key, if inserted. |
|
|
|
– |
Open cover -1- for negative
battery terminal. |
– |
Loosen nut -3- several turns
and disconnect battery terminal clamp -2-
of earth cable from battery terminal. |
Observe the following when connecting the battery -A-: |
|
|
|
– |
Unplug electrical connector -2-
at battery monitor control unit -J367--3-. |
– |
Fit battery terminal clamp of earth cable to negative
battery terminal “–” by hand. |
– |
Reconnect connector -2- to
battery monitor control unit -J367-. |
– |
Check time and adjust, if necessary. |
– |
Open windows completely, then close them. |
– |
Then, with windows closed, pull window regulator switches
until relay can be heard to switch. |
– |
Check convenience mode of the window regulators. |
With convenience closing activated, windows must close fully
without the need for holding the window regulator switch. |
Note
After the voltage supply has been switched back on, it still
takes several meters of travel for the ESP warning lamp to go
out. |
→ Chapter „Assembly overview – battery, vehicles without
high-voltage system“ |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
...
Caution
Observe the following instructions and precautions
on safety when working on pyrotechnic components:
...
Other materials:
Removing and installing bumper cover
Volkswagen R GmbH, optional equipment, “R Line” and “R”
Special tools and workshop equipment
required
Note
The removal and installati ...
Assembly overview - steering column switch module, with electronic ignition
lock
1 -
Starter button -E378-
Overview of fitting locations
→ Chapter
2 -
Steering column electronics control unit -J527-
With airbag coil connector and return ring with slip ring -F138-
...
Back massage function
Fig. 54 In the lower area of the driver
seat: button for back massage function
First read and observe the introductory information
and safety warnings When the back massage function is switched on, the lumbar
support moves and massages the lumbar region. The in/out position of the lumbar
...
© 2016-2024 Copyright www.vwgolf.org