Volkswagen Golf Service & Repair Manual: Dimensions – “e-Golf” lettering on rear lid
Note
| When fitting the lettering, observe the fitting notes → Anchor. |
| 1 - | Lettering |
- Model designation
| 2 - | Height dimension |
- 75.5 ± 1 mm, from lower edge of lettering to tail light
| 3 - | Horizontal dimension |
- 26.5 ± 1 mm, from outer edge of rear lid to lettering
Dimensions - lettering on rear lid, “GTI/GTD”
Note
When fitting the lettering, observe the fitting notes
→ Anchor.
1 -
Lettering
Model designation
2 -
...
Dimensions – lettering on rear lid, “R-Line”
Note
When fitting the lettering, observe the fitting notes
→ Anchor.
1 -
Lettering
Model designation
2 -
...
Other materials:
Assembly overview - brake caliper (PC57 brakes)
When carrying out repairs, install all parts supplied in repair kit.
Use only methylated spirits for cleaning the brake.
Apply thin coat of lithium grease -G 052 150 A2- to brake cylinder,
piston and seal.
1 -
Dust cap
...
Removing and installing heat exchanger for high-voltage battery
Special tools and workshop equipment
required
Hose clamps, up to 25 mm -3094-
Engine bung set -VAS 6122-
Pliers for spring-type clips -VAS 5024A-
Cooling sy ...
Overview of fitting locations - front keyless entry system, RHD vehicles
1 -
Front passenger door exterior handle
With front passenger door exterior handle contact sensor -G416-.
Removing and installing
→ Chapter
With front passenger side aerial for entry and start system -R135-.
Removing ...
