Volkswagen Golf Service & Repair Manual: Dimensions – lettering on wing, “R”
| 1 - | Emblem |
| 2 - | Height dimension |
- 5.0 ± 1 mm, from upper edge of lettering to edge of wing
| 3 - | Horizontal dimension |
- 1.5 ± 1 mm, from outer edge of wing to lettering
Dimensions – lettering on wing
Note
The dimensions shown here for “GTI” as an example are valid for all
emblems.
1 -
Emblem
Variations in appearance possible dependin ...
Removing and installing manufacturer emblem
Note
The emblem cannot be removed without damage.
Removing
–
Use a screwdriver -3- to carefully
lever manufacturer emblem -1- out of
...
Other materials:
Warning lamp
First read and observe the introductory information
and safety warnings
Display
Possible cause
Solution
The tailgate is open or not properly closed.
Do not drive
on!
Open the tailgate and then close it again.
Sev ...
Removing and installing alternator, vehicles with 1.2 l TSI engine, 1.4 l
TSI engine and 1.4 l TSI natural gas engine
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Removing
–
With ignition switched off, disconnect earth cable from
...
Removing and installing valve stem seals (cylinder head removed)
Special tools and workshop equipment
required
Removal and installation device for valve cotters -VAS
5161A- with guide plate -VAS 5161A/32-32-.
...
