Volkswagen Golf Service & Repair Manual: Dimensions – lettering on rear lid, “R-Line”
Note
| When fitting the lettering, observe the fitting notes → Anchor. |
| 1 - | Lettering |
- Model designation
| 2 - | Height dimension |
- 73 ± 1 mm, from upper edge of lettering to tail light.
| 3 - | Horizontal dimension |
- 50 ± 1 mm, from outer edge of rear lid to lettering
Dimensions – “e-Golf” lettering on rear lid
Note
When fitting the lettering, observe the fitting notes
→ Anchor.
1 -
Lettering
Model designation
2 -
...
Dimensions – lettering on wing
Note
The dimensions shown here for “GTI” as an example are valid for all
emblems.
1 -
Emblem
Variations in appearance possible dependin ...
Other materials:
Removing and installing window regulator motor -V14-/-V15-
Special tools and workshop equipment
required
Note
Removal and installation are only described for the left
window regulator motor. Removal ...
Introduction
This chapter contains information on the following subjects:
→ Switching the auxiliary heater on or off
→ Remote control
→ Programming the auxiliary heater
→ Operation
The auxiliary heater is supplied with fuel from the vehicle fuel tank and can ...
Fitting the rear towing eye
Fig. 248 Rear bumper on the right-hand
side: removing the cover
Fig. 249 Rear bumper on the right-hand
side: screwing in the towing eye
First read and observe the introductory information
and safety warningsThe towing eye is screwed into a threaded hole behind
a cover on the right of the ...
