Volkswagen Golf Service & Repair Manual: Dimensions - lettering on rear lid
Note
| When fitting the lettering, observe the fitting notes
→ Anchor. |
- Engine designation
- For technical designations without engine designation, another dimension
applies.
- 50.5 ± 1 mm, from upper edge of lettering to tail light
- Additional lettering is bonded 6.0 ± 1 mm under engine designation
- The height dimension for technical designations without engine
designation must measure 75.5 ± 1 mm from lower edge of lettering.
- 29.5 ± 1 mm, from outer edge of rear lid to lettering
- Side dimension for technical designations without engine designation
must measure 29.5 ± 1 mm.
- 26.5 ± 1 mm, from outer edge of rear lid to lettering
- 75.5 ± 1 mm, from lower edge of lettering to tail light
Note
When fitting the lettering, observe the fitting notes
→ Anchor.
1 -
Lettering
Model designation
2 -
...
Other materials:
Exploded view - mechatronic unit
1 -
Bolt
For securing mechatronic unit for dual clutch gearbox -J743- on
gearbox housing.
Qty 3, M8 x 35
Always renew after removing.
Specified torque and tightening sequence
→ Fig.
...
Removing and installing brake pads, front brakes
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Piston resetting appliance -T 10145-
...
Changing a wheel
Fig. 226 Changing a wheel: removing the
wheel bolts with the screwdriver handle
First read and observe the introductory information
and safety warningsRemoving the wheel
Read the checklist.
Loosen the wheel bolts.
Jack up the vehicle.
Using the hexagonal socket in the scr ...
© 2016-2026 Copyright www.vwgolf.org
Dimensions - lettering on rear lid, “GTI/GTD”