Volkswagen Golf Service & Repair Manual: Diagonal washout
| Diagonal washout on a tyre |
| Diagonal washout runs at an angle of approx. 45° to the
direction of rotation. |
| It usually occurs at one point only, but can also occur at
several points around the circumference of the tyre. |
| Washout occurs almost exclusively on the tyres on the
non-driven wheels, in particular at the rear left. Washout
occurs very often on some models, while it poses no problem at
all on other models. The effect is intensified by high toe-in
values. Toe-in values in the region of the lower tolerance
limits of the specified alignment values improve the wear
pattern. |
| The most pronounced diagonal washout is often found in the
area where the tyre components are joined. |
| Wheels with positive toe-in roll with a slip angle even
straight ahead. This leads to a diagonal stress in the contact
patch or footprint on the tyre/road surface. |
| This wear pattern is intensified when tyre pressure is too
low. To avoid such tread wear patterns, the toe-in values of the
two rear wheels should be identical and the specified tyre
pressures observed. |
| If you detect washout, you should fit the wheels on the
driven axle, assuming the washout is identified at an early
stage. Deeper washout cannot be repaired. |
| If a customer complains of “diagonal wear spots”, the toe
adjustment must be examined. If toe-in is correct, the cause of
the diagonal washout is very probably the tyre itself. |
| Tyres with diagonal washout caused by incorrectly set axle
geometry at the wheels are not covered by warranty. |
|
|
|
Unsuitable use of self-levelling adjustments on pneumatic
suspension system
The use of the offroad level is recommended only for driving
offroa ...
This wear pattern is found on the driven wheels of
high-performance vehicles that are frequently driven long
distances at high speeds.
At high ...
Other materials:
Removing and installing electronically controlled damping control unit
-J250-, saloon
Special tools and workshop equipment
required
Vehicle diagnostic tester
Removing
Location: electronically controlled damping control unit
-J250- is installed behind left luggage compartment s ...
Safety markings on battery
Safety markings on battery
1. -
Fires, sparks, naked flames and smoking are prohibited when
handling batteries. Avoid sparks as well as electrostatic
discharge when working with cables and electrical units. Avoid
short ci ...
Nuts and bolts
Loosen and tighten bolts and securing nuts for covers and
housings diagonally.
Avoid canting particularly sensitive parts such as comtrol
motor with control unit. Loosen and tighten them diagonally in
stages.
...
© 2016-2024 Copyright www.vwgolf.org
Outer shoulder wear
Wear in middle of tyre