Volkswagen Golf Service & Repair Manual: Cylinder block (pulley end)
- Assembly overview - poly V-belt drive, vehicles without air conditioner compressor
- Assembly overview - poly V-belt drive, vehicles with air conditioner compressor
- Assembly overview - sealing flange, belt pulley end
- Removing and installing poly V-belt, vehicles without air conditioner compressor
- Removing and installing poly V-belt, vehicles with air conditioner compressor
- Removing and installing tensioner for poly V-belt, vehicles without air conditioner compressor
- Removing and installing tensioner for poly V-belt, vehicles with air conditioner compressor
- Removing and installing vibration damper
- Removing and installing engine support
- Renewing crankshaft oil seal - belt pulley end
- Removing and installing sealing flange on pulley end
Assembly overview - poly V-belt drive, vehicles without air conditioner
compressor
1 -
Bolt
Renew
150 Nm +180°
Use counterhold -T10475- to loosen and tighten.
Risk of damage to engine caus ...
Other materials:
Removing and installing camshaft housing
Removing
–
Remove coolant pump
→ Chapter.
–
Remove air filter housing
→ Chapter.
–
Remove ignition coils
→ Chapter.
...
2-pack HS Vario clear coat
Designation:
2-pack HS Vario clear coat -L2K 769 K01 A5-
Issued 06.2013
Product description
2-pack HS Vario clear coat is a VOC compliant (VOC content <
420 g/l), high-gra ...
Removing and installing throttle valve module -GX3-
Throttle valve module -GX3- consists of
Throttle valve module -J338-
Throttle valve drive for electronic power control -G186-
Throttle valve drive angle sender 1 for electronic power
co ...
