Fig. 41 There must be a distance of at least 25 cm between the driver and the steering wheel The distance to the dash panel must be at least 10 cm in the knee area
Fig. 42 Correct seat belt routing and head restraint adjustment
First read and observe the introductory information and safety warningsThe following details the correct sitting positions for the driver and passengers.
If any vehicle occupants cannot assume a correct sitting position due to their physical build, they should contact a qualified workshop to find out about possible special modifications. The seat belts and airbags can only provide a maximum level of protection if a correct sitting position is assumed. Volkswagen recommends using a Volkswagen dealership for this purpose.
Volkswagen recommends the following seating position for your own safety and to reduce the level of injury in the event of a sudden braking manoeuvre or an accident:
The following applies to all vehicle occupants:
Additional points for the driver:
Additional points for the front passenger:
Wiring open circuit with two repair positions
Repair position with interlinked wire.
–
Place the wire to be repaired to the side at two points
(about 20 cm to both sides of the relevant repair position).
–
If necessary, unbind the wiring harnes ...
Removing and installing rear seat backrest
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331
Removing
–
Remove bench seat
→ Ch ...
Removing and installing fuel delivery unit/fuel gauge sender, vehicles with
four-wheel drive
Special tools and workshop equipment
required
Special wrench -T10202-
Removal wedge -3409-
Removing
...