Volkswagen Golf Owners Manual: Controls for the heating and fresh air system
Fig. 183 In the centre console: controls for the heating and fresh air system
First read and observe the introductory information
and safety warnings | Button, control | Additional information. Heating and fresh air system |
|---|---|
| Temperature ①. | Turn the regulator to set the temperature as required. The required interior temperature cannot be lower than the outside temperature as the heating and fresh air system cannot cool or dehumidify the air. |
 ...  |
|
| Blowers ②. | Setting 0: blower and heating and fresh air system switched off. Setting 6: highest blower setting. |
 |
|
| Air distribution ③. | Turn the control to direct the airflow exactly as required. |
 |
Air distribution to the windscreen. |
 |
Air distribution to the upper body via the air vents in the dash panel. |
 |
Air distribution to the upper body and the footwell. |
 |
Air distribution to the footwell. |
 |
Air distribution to the windscreen and the footwell. |
 |
Rear window heating: only functions when the engine is running and switches off automatically after approximately 10 minutes. |
 |
Air recirculation mode . |
 , 
|
Button for the seat heating . |
Settings for optimal road visibility
- Switch off air recirculation mode .
- Set blower to level 1 or 2.
- Set the temperature selector to the required position.
- Open and position all vents on the dash panel .
- Turn the air distribution controller to the desired position.
Operation via the infotainment system
First read and observe the introductory information
and safety warnings Various Climatronic settings can also be adjusted via
the infotainment system.
Opening the Air conditioning menu
Pre ...
Information on the air conditioning system
First read and observe the introductory information
and safety warnings The cooling system for the vehicle interior only works
when the engine is running and the blower is switched on.
The air ...
Other materials:
Removing and installing injectors
Special tools and workshop equipment
required
Tool set for FSI engines -T10133 C- with -T10133/16 A- and
-T10133/19-
Removing
Risk of functional impair ...
Introduction
This chapter contains information on the following subjects:
→ Overview of the menu structure
→ Using the selection menu in the instrument cluster
→ Button for the driver assist systems
→ Selection menu
→ Driving data
→ ...
Measuring axial clearance of crankshaft
Risk of damage to bearing pedestals when the
crankshaft is removed.If the bolts of the crankshaft bearing cap are
loosened, the bearing pedestals of the cylinder block will be deformed,
and damage to the bearings will result.Never remove the crankshaft.
Special tools ...
