Volkswagen Golf Service & Repair Manual: Control units
- Overview of fitting locations – control units, front of LHD vehicles
- Overview of fitting locations – control units, front of RHD vehicles
- Overview of fitting locations – control units, rear
- Assembly overview - control units, LHD vehicles
- Assembly overview - control units, RHD vehicles
- Assembly overview - data bus diagnostic interface
- Removing and installing onboard supply control unit -J519-, LHD vehicles
- Removing and installing onboard supply control unit -J519-, RHD vehicles
- Removing and installing data bus diagnostic interface -J533-
- Removing and installing bracket for onboard supply control unit -J519-, LHD vehicles
- Removing and installing bracket for onboard supply control unit -J519-, RHD vehicles
- Renewing bracket for onboard supply control unit -J519-, LHD vehicles
- Removing and installing bracket for parking aid control unit -J446-/park assist steering control unit -J791-, LHD vehicles
- Removing and installing engine sound generator control unit -J943-, vehicles with active sound, Golf GTD
Removing and installing fuse holder, battery
Removing
–
With ignition switched off, disconnect earth cable from
battery
→ Chapter.
...
Overview of fitting locations – control units, front of LHD vehicles
1 -
Data bus diagnostic interface -J533-
Assembly overview
→ Chapter
2 -
Bracket
Assembly overvie ...
Other materials:
Removing and installing rear left vehicle level sender -G76-, torsion beam
axle
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Removing
–
Disconnect co ...
Deactivating APP function of wiper motor
The windscreen wiper system is equipped with an APP function
(alternating park position).
With the APP function, the wiper is moved up slightly once
it has reached the lowest position. This occurs every second
time the wiper system is sw ...
Separating engine and gearbox
Special tools and workshop equipment
required
Shackle -10 - 222 A /12-
Hooks -10 - 222 A /2-
...
