Volkswagen Golf Service & Repair Manual: Contact corrosion
Contact corrosion can occur if unsuitable fasteners (bolts,
nuts, washers, etc.) are used. |
Therefore, only fastening elements with a special surface
coating are installed in the vehicle. |
In addition, rubber and plastic parts as well as adhesives
are made of electrically non-conductive materials. |
If there is any doubt about the suitability of parts, a
general rule is to use new parts
→ Electronic Parts Catalogue. |
Please observe the following: |
Use only Genuine replacement parts which are tested and
compatible with aluminium. |
Use only Volkswagen Genuine Accessories. |
Damage due to contact corrosion is not covered by warranty. |
|
|
|
Mark lines prior to removal to prevent them from being
interchanged and to ensure that they are fitted in their
original positions. This applies for fuel, hydraulic a ...
Other materials:
Assembly overview - coolant pipes
1 -
Coolant hose
2 -
Coolant pipe
Clipped onto intake manifold (bottom)
To remove, remove intake manifold
→ Chapter.
3 -
Bolt
8 Nm
4&nb ...
Checking airbag securing parts after an accident
All damaged securing parts must always be renewed. It is not
permissible to bend the components back into shape or
»make them fit«
The following components must be checked after the relevant
airbag has been triggered.
...
Drink holders in the rear centre armrest
Fig. 120 Drink holder in rear centre armrest:
examples of ways to adjust drink holder for different purposes
Fig. 121 Drink holders in the rear centre
armrest
First read and observe the introductory information
and safety warnings
To open, fold the centre armrest down.
To close ...
© 2016-2024 Copyright www.vwgolf.org