Volkswagen Golf Service & Repair Manual: Contact corrosion
Contact corrosion can occur if unsuitable connecting
elements (screws, bolts, nuts, washers, etc.) are used. |
For this reason, only connecting elements with a special
surface coating are fitted in the vehicle. |
Moreover, certain rubber or plastic parts as well as
adhesives made of electrically non-conductive materials. |
If there is any doubt about the suitability of parts, a
general rule is to use new parts
→ Electronic Parts Catalogue. |
|
Routing and securing lines |
In order to rule out mix-ups and ensure that
lines/wires/cables/hoses/pipe are all installed in their
original position, the lines for the fuel, hydraulic systems,
vacuum systems and the activated charcoal filter, for example,
as well as electrical wires/cables must be marked appropriately
before they are removed. If necessary, take a photo or make a
sketch. |
Because of the lack of space in the engine compartment, make
sure that all lines are sufficiently far away from all moving or
hot components. |
|
Installing coolers, condensers and radiators
Even if installed correctly, the radiator, the condenser and
the charge air cooler may have small dents in their fins. This
does not mean that these components have been damaged. It is not
permissible to renew radiators, condensers or charge air coolers
only because of such minor dents. |
|
|
|
When working on the fuel supply and injection system,
observe the following “5 rules” for cleanliness:
Thoroughly clean all unions and surr ...
Other materials:
Removing and installing frequency modulation (FM) frequency filter
-R178-/-R179-
Note
Removal and installation of the frequency modulation (FM)
frequency filter in negative wiring -R178- are described for the
right side. Removal and installation of the frequency modulation
(FM) frequency filter in positive wiring -R179- for ...
Removing and installing Bowden cable for remote release mechanism for seat
backrest
Note
Removal and installation are described for the left vehicle side.
Follow same instructions for the right side as appropriate.
Removing
Bowden cable on backrest end
–
Remove rear seat backrest
→ Chapter.
...
Introduction
This chapter contains information on the following subjects:
→ Contents of the breakdown set
→ Preparation
→ Sealing and inflating tyres
→ Test after driving for 10 minutes
You can use the breakdown set (tyre mobility set) to safely seal any tyre damage
cause ...
© 2016-2024 Copyright www.vwgolf.org