Volkswagen Golf Owners Manual: Consumer information
- Introduction
- Information stickers and plates
- Using the vehicle in other countries and continents
- Radio reception and aerials
- Component protection
- Volkswagen repair information
- Declaration of conformity
- Recycling and scrapping end-of-life vehicles
- Declaration of conformity for wheels and tyres
Rodent proofing
First read and observe the introductory information
and safety warnings Rodent proofing equipment is made up of special brushes
and casings and impedes entry to the engine compartment by rodents ...
Introduction
This chapter contains information on the following subjects:
→ Information stickers and plates
→ Using the vehicle in other countries and continents
→ Radio recepti ...
Other materials:
Balancing wheel, balancing wheel on stationary wheel balancer
Before you start balancing the wheels, the following
requirements must be met.
Tyre pressure must be OK.
Tread must not be worn on one side. Tread depth should be at
least 4 mm.
T ...
Balancing wheel, balancing wheel with finish balancer
Note
Before working with a finish balancer, the mechanic needs to
have been instructed by the manufacturer of the balancer.
To balance the wheels, set the wheels of the driven axle on
the sensor platforms. On front-w ...
Removing and installing rear left vehicle level sender -G76-, torsion beam
axle
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Removing
–
Disconnect co ...
