Volkswagen Golf Service & Repair Manual: Connecting brake pedal to brake servo

Volkswagen Golf Service & Repair Manual / Brake system (hybrid) / Brake, brake mechanics / Brake pedal / Connecting brake pedal to brake servo

–	Hold ball head of push rod in front of mounting and push brake pedal in direction of brake servo, so that the ball head clicks into place.

–	Check engagement by pulling briefly on brake pedal.

Continue installation in reverse order.

Connecting brake pedal to brake servo

Separating brake pedal from brake servo

Special tools and workshop equipment required Release tool -T10159- – ...

Removing and installing brake pedal

It is not possible to remove the brake pedal separately. – To be able to remove it, pedal cluster with mounting bracket must be removed ...

Other materials:

Brush grinder set -VAS 6776
Designation: Brush grinder set -VAS 6776- Product description: The device is designed to clean surfaces and to remove corrosion in areas that are difficult to reach. Suitable for joints, groo ...

Removing and installing TV tuner, eGolf
Special tools and workshop equipment required Protective cap for wiring harness connector -VAS 6223/9- If the control unit is replaced, select the Replace function of the resp ...

Warning and indicator lamps
First read and observe the introductory information and safety warnings Lit up Possible cause Solution Engine oil level is too low. Switch off the engine. Check the engine oil level . ...