VW Golf manuals

Volkswagen Golf Service & Repair Manual: Connecting air conditioner service station for measuring and checking

Depending on the type of equipment chosen, there may be variations in the required procedure; therefore always follow the user's manual for the equipment being used.
  Note
Always follow the procedure described in the user's manual for your air conditioner service station -VAS 6007A- (or later model).
The charging hoses must only be connected according to the following work procedure to prevent air or moisture from entering the refrigerant circuit:
–  Switch off ignition.
–  Connect air conditioner service station to power supply.
–  Unscrew sealing caps from service station connections or from connections with valve (see vehicle-specific refrigerant circuit).
→ Rep. gr.87
–  Evacuate charging hose.
  Note
Connect the charging hose to the service connections of the refrigerant circuit using quick-release couplings.
  Caution
Do not open the valves in the low- or high-pressure sides when the engine is running. Otherwise, if the air conditioning is switched on, the air conditioner compressor or the air conditioner service station may be destroyed by a “short circuit” between the high- and low-pressure sides of the refrigerant circuit.
–  Turn hand wheel into quick-release coupling adapter until the valve in the service connection is definitely open (observe pressure gauge; do not over-tighten valve).
–  Start the engine and perform the planned tests and measurements.
–  Compare determined values with specifications → Chapter.
–  Before disconnecting the quick-release coupling, close it by turning out the handwheel.
   
Important notes for working with the air conditioner service station
To operate the air conditioner service station -VAS 6007A-, the following must be observed (also applies to other and latest available air conditioner service station ...

Draining refrigerant circuit using air conditioner service station
  WARNING High-voltage on high-voltage system. Danger of electric shock on air conditioner compressor! ...

Other materials:

Removing and installing bonnet lock, RHD vehicle
Special tools and workshop equipment required         Torque wrench -V.A.G 1331- –  Open bonnet. –  Remove Bowden cable on mounting bracket ...

Overview of fitting locations – control units, front of LHD vehicles
1 -  Data bus diagnostic interface -J533- Assembly overview → Chapter 2 -  Bracket Assembly overview → Chapter 3 -  Onboard supply control unit -J519- ...

Safety precautions for working on vehicles with start-stop system
Risk of injury due to unexpected engine start In vehicles with activated Start/Stop system, the engine may start up unexpectedly. The status of the Start/Stop system is indicated by a message in the dash panel insert. –  Deactivate Start/Stop syste ...

© 2016-2024 Copyright www.vwgolf.org