Volkswagen Golf Service & Repair Manual: Conducting a road test before balancing wheels

Volkswagen Golf Service & Repair Manual / Running gear, axles, steering / Wheels, tyres, axle align / Vibration due to wheels/tyres - causes and rectification / Conducting a road test before balancing wheels

If a customer brings a vehicle to the workshop complaining about “vibration”, a road test is essential prior to balancing the wheels.

This will give you information about the nature of the vibration.

You will be able to determine the speed range in which vibration occurs.

–	Raise the vehicle on a lifting platform immediately after the road test.

–	Mark installation position on tyre.

Tyre position	Marked with …
Front left tyre	FL
Front right tyre	FR
Rear left tyre	RL
Rear right tyre	RR

–	Remove wheels.

–	Balance wheels.

Causes of vibration

Vibration can have a number of different causes. Vibration can also be caused by tyre wear. Tyre wear caused by driving is not always evenly spread across the entire ...

Balancing wheel, conditions

Before you start balancing the wheels, the following requirements must be met. Tyre pressure must be OK. Tread mus ...

Other materials:

Removing and installing washer jets
Removing Note Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way. – Remove pop-up cylinder → ...

Assembly overview - Lambda probe
Note New lambda probes are coated with an assembly paste. This paste must not get into the slots on the Lambda probe body. In the case of a used Lambda probe grease only the thread with high-temperature paste. This p ...

Removing and installing tyre pressure sensor, tyre pressure sensor without valve, production version
Special tools and workshop equipment required Torque wrench -V.A.G 1410- Carry out the following work: Removing – R ...