Assembly overview - belt pulley, Sanden air conditioner compressor
1 -
Nut
25 Nm
Note
In order to protect the thread of the air conditioner compressor
drive shaft an additional plastic cap is fitted (not shown in
illustration).
–
To unfasten and tighten the hex ...
Overview of fitting locations - fuel supply system, Golf and Golf GTE
Note
Fuel lines are secured with O-type clips. These O-type clips
must always be renewed every time they are removed.
Start engine if fuel tank was empty. Then start the
auxiliary heater repeatedly until the heater d ...
Bleeding hydraulic system following standard procedure
Note
Bleeding the hydraulic system using brake filling and
bleeding equipment -VAS 5234- is described.
A pre-pressure of 2 bar is required for bleeding the ABS
hydraulic unit -N55-.
Specia ...