First read and observe the introductory information and safety warnings
The Coming Home function is switched on manually. However, the Leaving Home function is controlled automatically by a twilight sensor.
Coming Home | Action |
---|---|
Switching on |
– Switch off the ignition. – Operate the headlight flasher for approximately one second . The Coming Home lights are switched on when the driver door is opened. The switch-off delay starts when the last vehicle door or the tailgate has been closed. |
Switching off |
– Occurs automatically once the set switch-off delay has elapsed. – Occurs automatically if another vehicle door or the tailgate is opened within approximately 30 seconds of it being switched on. – Turn the light switch to position . – Switch on the ignition. |
Leaving Home | Action |
---|---|
Switching on | – Unlock the vehicle when the light sensor is in position and the twilight sensor that it is dark. |
Switching off |
– Occurs automatically once the switch-off delay has elapsed. – Lock the vehicle. – Turn the light switch to position . – Switch on the ignition. |
Surround lighting in the exterior mirrors
The surround lighting in the exterior mirrors lights up the area directly around the doors while you are entering or exiting the vehicle. It is switched on when the vehicle is unlocked, when opening the driver door or when the Coming Home or Leaving Home lighting function is active. If the vehicle is equipped with a light sensor, the surround lighting in the exterior mirrors will only be switched on when it is dark.
The length of the switch-off delay can be adjusted, or the function can be activated or deactivated, using the button and the and Light function buttons in the infotainment system .
When the Coming Home function is switched on, no acoustic warning will sound when the driver door is opened to remind you that a light is still switched on.
Vapour pressure
In an enclosed container that is not completely full,
refrigerant evaporates as vapour at the surface in a quantity
sufficient to form an equilibrium between vapour and liquid.
This equilibrium develops under pressure and is often called
vapour pressure. ...
Assembly overview - FS III front brake
Note
After every brake pad change, depress brake pedal firmly several
times with vehicle stationary, so that brake pads are properly seated in
their normal operating position.
Use the brake filling and bleeding equipment -VAS 5234- to draw off
brake ...
Removing and installing brake pads or linings
Special tools and workshop equipment required
Vehicle diagnosis, testing and information system -VAS 5051-
Tool set for brake bleeding -VAS 6564-
Insert tool with ratchet -VAS 6784-
Bit attachment (7 mm) -T10503-
...