Volkswagen Golf Service & Repair Manual: Clutch
- Assembly overview - dual clutch
- Removing dual clutch
- Installing dual clutch
- Renewing input shaft seal
- Renewing oil seal for inner input shaft
Adjusting clutch engagement
The position of the engagement bearings “K 1” and “K 2” must
only be adjusted after the following work:
Clutch has been renew ...
Assembly overview - dual clutch
1 -
Hinge mounting
For large engaging lever “K 1”
Cannot be renewed.
2 -
Ball pin
For small ...
Other materials:
Removing and installing speed sensor on rear axle -G44-/-G46-, vehicles with
four-wheel drive
Note
Removal and installation is described for the rear left
speed sensor. Removal and installation of the rear right speed
sensor is analogous.
Removing
–
Raise vehicle.
&nbs ...
Dimensions
Fig. 21 Dimensions
First read and observe the introductory information
and safety warnings The data in the table apply to the most basic German
model.
The specified values can vary due to different tyre and wheel sizes, if additional
equipment is fitted, for different model versions, for ...
Removing and installing striker pin
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Removing
–
Remove trim for rear lid lock
→ General bod ...
