| – | Use adhesive remover -D 002 000. 10- as cleaning agent. Observe the appropriate safety precautions when performing this work. |
WARNING
|
| – | First clean painted surface as well as possible using a dry cloth. Remove residue using adhesive remover -D 002 000. 10-. |
| – | Cleaning plastic trim: allow adhesive sealant to cure (approx. one hour) and then peel off. |
Preparing body flange for fitting
WindscreenAssembly overview - side trim panel
Note
The illustration shows the side trim panel on the left side. The
right-hand side is similar (mirror image of left-hand side).
1 -
Side trim panel
Removing and installing
→ Chapter
2 -
Clip
...
Removing and installing inlet camshaft oil seal, pulley end, engine codes
CPTA, CHPA, CZEA, CZDA
Special tools and workshop equipment
required
Assembly tool -T10478 B-
Removing
–
Detach toothed belt from camshafts
→ Chapter ...
Removing and installing rear underbody cover – petrol/diesel
Note
The removal and installation procedures may have to be modified
slightly depending on engine fitted.
–
Loosen lock washer -3-.
–
Unclip spreader rivet -2- and remove
bolt -4-.
–
Remove rea ...