Never carry out any work on the engine or in the engine compartment if you are not familiar with the requisite procedures and general safety requirements, or if you only have access to incorrect operating equipment, service fluids, and unsuitable tools . The work should be carried out by a qualified workshop if you are uncertain. Please ensure that the following are checked regularly, preferably every time you fill the tank:

Windscreen washer fluid level Windscreen wiper and washer Windscreen wipers Windscreen washer

Engine oil level Engine oil Engine oil Engine compartment Engine oil_5 Oil see Engine oil_5

Engine coolant level Coolant Coolant Engine compartment Coolant_4 Engine coolant see Coolant_4

Brake fluid level Braking, stopping and parking Brakes Parking

Tyre pressure Wheels and tyres Wheels and tyres Tyres see Wheels and tyres_0
Information on changing bulbs .
Checks when filling the tank
FuelAssembly overview - drive shaft, triple roller joint AAR3300i
1 -
Bolt
Renew after removing
Loosening and tightening
→ Chapter
Before fitting, clean the threads in the CV joint using a thread
tap.
200 Nm +180°
2 - ...
Assembly overview – gas discharge headlight with dynamic high beam control
and LED daytime running light, »R«
1 -
Headlight
Front left headlight -MX1-
Front right headlight -MX2-
Removing and installing
→ Chapter
2 -
Side light bulb
Left side light bulb -M1-
...
Removing and installing fuel tank flap release button -E319-
Special tools and workshop equipment
required
Removal wedge -3409-
Note
The removal and installation procedures are described for
LHD vehicles. Removal and ins ...