Volkswagen Golf Service & Repair Manual: Checking radial clearance of conrods
Special tools and workshop equipment
required |
– |
Remove conrod bearing cap. |
– |
Clean bearing cap and bearing journal. |
– |
Place a Plastigage corresponding to the width of the bearing
on the journal or into the bearing shells. |
– |
Fit conrod bearing cap and tighten to 30 Nm without turning
further angle and without rotating crankshaft. |
– |
Remove conrod bearing cap again. |
– |
Compare width of Plastigage with the measurement scale. |
Radial clearance: 0.028 … 0.065 mm. |
|
|
|
Checking piston
–
Using a micrometre, measure approx. 10 mm from the lower
edge, perpendicular to the piston pin axis.
...
Other materials:
General safety regulations
To prevent personal injury and material damage to the
vehicle, observe the following:
WARNING
Risk of injury and accident by accidental engagement
of gear while engine is running.
...
Removing broken rear window
–
Protect body and interior from glass splinters.
–
Remove pieces of glass up to adhesive sealing material.
–
Pull off connections for rear window heating and aerial.
...
Vehicles with torsion beam axle
1 -
Rubber mounting
Renew if damaged
2 -
Bolt
20 Nm
3 -
Mounting
Renew if damaged
4 -
Rear silencer
In initial equipmen ...
© 2016-2024 Copyright www.vwgolf.org