Volkswagen Golf Service & Repair Manual: Checking operation of belt buckle
– |
Push latch plate into belt buckle until it engages audibly.
Check whether locking mechanism is properly engaged by pulling
firmly on belt webbing. |
|
If latch plate fails even once to engage properly in belt
buckle during at least 5 tests, renew seat belt complete with
belt buckle. |
Checking release mechanism |
– |
Release seat belt by pressing button on belt buckle with
finger pressure. When belt is slack, latch plate must spring out
of belt buckle on its own. |
|
Carry out test at least 5 times. If latch plate fails even
once to spring out of buckle, renew seat belt complete with belt
buckle. |
WARNING
Under no circumstances whatsoever may lubricant be
used to eliminate noise or stiffness in belt buckle
buttons. |
|
|
|
|
The inertia reel has two locking functions.
The first locking function is triggered by the belt being
jerked out of the reel (belt exten ...
Plastic-coated fittings show fine, parallel scoring after
stress on belt system (when belt was fastened during accident).
(On the other hand, wear caused by frequent ...
Other materials:
Removing and installing Bowden cable B for entry assistance
Removing
–
Remove front seat
→ Chapter.
–
Secure front seat on seat repair stand
→ Chapter.
–
Move front seat to highest position.
...
Bleeding fuel line to metering pump -V54- (filling with fuel)
Note
Air/fuel vapour in the fuel supply to the auxiliary heater
can lead to malfunction when the auxiliary heater is in the
sparking mode. To prevent air/fuel vapour from being drawn in by
the metering pump -V54- and conveyed to the auxili ...
Button for the driver assist systems
Fig. 18 On the turn signal and main beam
lever: button for driver assist systems
First read and observe the introductory information
and safety warnings You can switch the driver assist systems listed in the
Assistant menu on and off with the button on the turn signal and main beam lever
...
© 2016-2024 Copyright www.vwgolf.org