Volkswagen Golf Service & Repair Manual: Checking inertia reel (locking mechanism)

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Technical data / Safety information / Checking inertia reel (locking mechanism)

The inertia reel has two locking functions.

The first locking function is triggered by the belt being jerked out of the reel (belt extension acceleration).

Test 1

–	Pull belt out of inertia reel with firm jerk.

Will not lock - renew seat belt complete with buckle.

If difficulties are experienced when belt is extended or retracted, first check whether position of inertia reel has been altered.

The second locking function is triggered by a change in vehicle speed (vehicle-dependent locking function).

Test 2

WARNING

For safety reasons, the road test should be carried out on a traffic-free stretch to ensure that other road users are not endangered.

–	Put on seat belt.

–	Accelerate vehicle to 20 km/h and then carry out emergency braking with foot brake.

If seat belt is not locked by locking mechanism during braking procedure, renew seat belt complete with buckle.

Visually inspecting belt buckle

Inspect belt buckle for cracks and chips.

If damage is determined, renew seat belt complete with belt buckle.

Checking belt webbing

Procedure – Pull belt completely out of inertia reel or lap belt adjustment plate. – Check belt we ...

Checking operation of belt buckle

Checking belt buckle – Push latch plate into belt buckle until it engages audibly. Check whether locking mechanism is properly engaged ...

Other materials:

Removing and installing earth wire with battery monitor control unit -J367-, vehicles with high-voltage system
Special tools and workshop equipment required Torque wrench -V.A.G 1783- Removing – Switch off ignition. – ...

Brake fluid
Fig. 144 In the engine compartment: cap on the brake fluid container First read and observe the introductory information and safety warnings Brake fluid will gradually absorb water from the surrounding air. The brake system will be damaged if there is too much water in the brake fluid. T ...

Removing and installing rear underbody cover – e-Golf
Removing – Remove bolts -2-. – Unscrew nuts -3-. – Remove underbody cover -1-. Installing Install analogously in reverse order, but note the following: Specified torque ...