Volkswagen Golf Service & Repair Manual: Checking holding pressure, engine code CWVA

Volkswagen Golf Service & Repair Manual / Fuel supply system - Petrol engines / Fuel supply, gas operation / Fuel pump / Checking holding pressure, engine code CWVA

Checking holding pressure, engine code CWVA

Special tools and workshop equipment required

Removal wedge -3409-

Pressure tester -VAS 6550-

Connector cable -VAS 6550/3-3-

Connector cable -VAS 6550/3-4-

Vehicle diagnostic tester

Prerequisites:

Voltage supply OK → Chapter.

–	Observe safety precautions → Chapter.

–	Observe rules for cleanliness → Chapter.

–	Pull off supply line -1-. Separate plug-in connectors → Chapter.

The fuel system is pressurised.Risk of injury due to fuel which may spurt out.Wear eye protection.Wear protective gloves.Release pressure: place clean cloth around connection and carefully open connection.

–	Collect escaping fuel with a cleaning cloth.

Checking holding pressure, engine code CWVA

–	Connect hose -VAS 6550/1- to connection -A- of pressure tester -VAS 6550-.

–	Connect hose -VAS 6550/1- to fuel supply line -1- leading to engine.

–	Connect hose -VAS 6550/2- to connection -B- of pressure tester -VAS 6550-.

–	Use hose -VAS 6550/2- to connect fuel line leading to fuel tank with pressure tester -VAS 6550-.

–	Ensure plug-in connectors are secured properly by pulling.

Checking holding pressure, engine code CWVA

–	Ensure that drain tap -C- on pressure tester-1- is closed.

–	Shut-off valves -A- and -B- on pressure tester-1- are open.

–	Connect vehicle diagnostic tester.

–	Select final control diagnosis for fuel pump in vehicle self-diagnosis program.

Note

The fuel pump is now actuated to build up fuel pressure.

If the final control diagnosis is to be carried out several times in succession, it may be necessary to start the engine briefly before repeating the final control diagnosis.

–	Read off fuel pressure on pressure gauge.

Specification: Approx. 4.0 bar.

If fuel pressure is OK, check holding pressure → Chapter.

If the specification is exceeded:

–	Pressure limiting valve in fuel delivery unit is defective.

–	Renew fuel delivery unit → Chapter.

If the specification is not attained:

Proceed as follows to check fuel pressure at fuel delivery unit:

Golf SV:

–	Remove right rear seat → General body repairs, interior; Rep. gr.72.

Checking holding pressure, engine code CWVA

–	Partially detach cover -1- in floor covering at parting line -arrow-.

–	Do not detach cover completely from floor covering in order to ensure it is reinstalled in the correct installation position.

–	Detach it just enough that the cover can be folded upwards.

–	Fold up cover in -direction of arrow-.

Golf and Golf Estate:

–	Remove rear bench seat → General body repairs, interior; Rep. gr.72.

Checking holding pressure, engine code CWVA

Continuation for all vehicles:

–	Unclip cover -1- for flange at retaining tabs -arrows-, using removal wedge -3409-.

Checking holding pressure, engine code CWVA

–	Unclip sealing grommet -1- downwards from cover -2-.

–	Push cover -2- back along wiring harness -3-.

Checking holding pressure, engine code CWVA

–	Pull fuel line -1- off flange. Separate plug-in connectors → Chapter.

Checking holding pressure, engine code CWVA

–	Connect pressure tester -VAS 6550- with hose -VAS 6550/3-4- to fuel delivery unit -1-.

–	Connect pressure tester -VAS 6550- and fuel supply line -2- by means of hose -VAS 6550/3-3-.

–	Ensure plug-in connectors are secured properly by pulling.

Checking holding pressure, engine code CWVA

–	Ensure that drain tap -C- on pressure tester-1- is closed.

–	Shut-off valves -A- and -B- on pressure tester-1- are open.

–	Repeat final control diagnosis to build up fuel pressure.

If specification is attained:

–	Check fuel lines for possible restrictions (kinks) or blockages.

–	Check fuel line for leaks and damage.

Checking holding pressure, engine code CWVA

If the specification is not attained:

–	Remove fuel delivery unit → Chapter and check for contamination.

–	Check that all hoses are connected -arrows-.

–	Check fuel lines for possible restrictions (kinks) or blockages.

–	Check fuel lines for leaks and damage.

If no fault is found:

–	Fuel pump is defective, renew fuel delivery unit → Chapter.

Checking holding pressure, engine code CWVA

Checking holding pressure

Special tools and workshop equipment required Removal wedge -3409- Pressure tester -VAS 6550- Connector cable -VAS 6550/3-3- ...

Checking holding pressure

Special tools and workshop equipment required Pressure tester -VAS 6550- Removal wedge -3409- Connector cable -VAS 6550/3-3- ...

Other materials:

Before operating the air conditioning system after recharging with refrigerant
After installing a new air conditioner compressor or filling with fresh refrigerant oil (e.g. after blowing out refrigerant circuit), turn compressor pulley 10 revolutions by hand before starting engine. This will prevent damage to the air conditioner ...

Safety precautions when painting natural gas-powered vehicles
DANGER! Excessively high drying temperatures endanger life! High temperatures increase the pressure in the tank for natural gas or liquefied petroleum gas. Excessive pressure can cause the tank for natural ...

Overview of fitting locations - aerial systems
1 - Frequency modulation (FM) frequency filter in positive wire -R179- On window frame to the left of the rear lid FM trap circuit (+) Has the task of preventing the aerial signals being shorted to earth R ...