Volkswagen Golf Service & Repair Manual: Checking condensation drainage

Volkswagen Golf Service & Repair Manual / Heating, air conditioning / Air conditioner / Front heater and air conditioning unit / Checking condensation drainage

Checking

–	Remove right centre console trim in footwell → General body repairs, interior; Rep. gr.68.

–	Carefully fold back floor covering in area of condensation drain hose so that condensation drain hose is visible.

–	Lug -arrow- on connecting piece must engage in guide -2-.

Checking condensation drainage

–	Insert the condensation drain hose -6- in the body opening until it is heard to engage.

Note

It must be possible to push condensation drain hose -1- onto the heater and air conditioning unit connection without tension.

The condensation drain hose must be fitted securely to the condensation drain connection on the tunnel.

The sealing lip -2- must not be seated loosely on body aperture.

The retainer tabs -arrows- must be fully engaged.

Specified torques:

Centre console; Assembly overview - centre console → General body repairs, interior; Rep. gr.68.

Checking condensation drainage

Removing and installing evaporator temperature sensor -G308-, RHD vehicles

Special tools and workshop equipment required Removal wedge -3409- Note ...

Removing and installing condensation drainage (LHD)

Removing – Remove right centre console trim in footwell → General body repairs, interior; Rep. gr.68. Risk o ...

Other materials:

Primary locking element
The primary locking mechanism is what fixes an individual crimp contact in the contact housing. If necessary, any housing catches in place (secondary locking mechanisms) must be released or removed prior to disengaging the contacts using ...

Releasing gas and draining rear gas-filled shock absorbers, conventional shock absorbers
Clamp gas-filled shock absorber vertically in vice. WARNING Safety goggles must be worn when drilling. – Drill a 3 mm hole -A- through ...

Removing and installing trailer detector control unit -J345-
Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode → Vehicle diagnostic tester. Removing � ...