Volkswagen Golf Service & Repair Manual: Checking adjustment of assembly mountings (engine and gearbox mountings)

Volkswagen Golf Service & Repair Manual / 4- cylinder injection engine(1.4 1 direct inction. turbocharger) / Engine assy, cylinder blook, crankcase / Assembly mountings / Checking adjustment of assembly mountings (engine and gearbox mountings)

Procedure

The following specifications must be obtained:

There must be a distance of -a- = 10 mm between engine support -2- and engine mounting -1-.

Side surface of engine support casting -2- must be located parallel to support arm of engine mounting -1-.

Distance -b- = distance -b-.

Note

Distance -a- = 10 mm can be checked with a metal rod of suitable size, or similar.

–	If the dimension is too small or too high, adjust assembly mountings → Chapter.

Checking adjustment of assembly mountings (engine and gearbox mountings)

Removing and installing pendulum support

Remove noise insulation → General body repairs, exterior; Rep. gr.66. – ...

Adjusting assembly mountings

Procedure – Remove battery tray → Electrical system; Rep. gr.27. ...

Other materials:

Preparing old undamaged windows for fitting
Cutting back adhesive bead WARNING Keep bonding surface free of dirt and grease. Do not treat bonding surface with activator immediately after cutting back. Do not pr ...

Checking and adjusting selector lever cable
Brief description Selector lever cable must be removed from gearbox so that its ease of movement can be checked. Put removed end down so it does not rub against anything. The selector lever must be moved and then the cab ...

Starting conditions for auxiliary heater, supplementary heater mode
Terminal 15 (ignition) on Engine speed > 600 rpm Coolant temperature < 72 °C Ambient temperature < 5 °C Reserve fuel level not reached ...